針對SMT車間的空調解決方案啡邑，SMT車間的特點為生產工作場所丽焊，SMT車間有大量發熱設備，SMT車間內生產人員不會太多。根據SMT車間的特點准验，空調選型推薦如下：HIMOD flagship 65U機型。

This is a solution of A/C for a SMT workshop. The characteristic of the SMT workshop is the place of production, and there is a large amount of equipment. Production personnel are not too much. According to the characteristics of the space for the SMT workshop, the selection of model is recommended as HIMOD flagship 65U.

經濟效益評估：(Economic Evaluation)

一缔御、  該SMT車間需安裝空調面積總計800平方米左右惜颇，有大量發熱設備皆刺，對溫濕控制及節能有要求，依據實際情況每平米所需制冷量平均按350W計算凌摄，總需求的280KW制冷量羡蛾。

The total area is of about 800 square meters for the SMT workshop, and there is a large amount of heat source, and it requires the temperature and humidity control and energy saving features. Required cooling capacity per square meter on average calculated based on the actual situation according to 350W, the total demand for cooling capacity is of 280KW.

二、  要滿足該項目280KW的制冷量锨亏，需使用HIMOD flagship 65U機組5套裝機痴怨。

To meet the cooling capacity of 280KW, this project is needed to use five sets of unit (HIMOD flagship 65U).

三、  經濟效益對比估算：傳統空調滿足280KW制冷量的輸入功率至少為105KW左右器予，而HIMOD flagship 65U機組5套主機的輸入功率合計為65.1KW浪藻，主機部分省電38%，全年共計節省電費7.6萬元以上乾翔。(按1年運行8個月爱葵，1月運行30天，1天運行8小時反浓，用電按1元1度計算)

Comparison of economic benefit estimation: the traditional air-conditioning input power (280KW cooling capacity) is at least about 105KW, and the HIMOD flagship 65U input power per set is of 13.2KW. The energy saving is up to 38%. The annual saving is more than 76000 CNY. (According to 8 months per year, 30 days per month, 8 hours per day of operation, electricity by 1 CNY/1 degree calculation)